Bộ khởi động động cơ - đảo chiều trái phải
ELR H5-IES-SC- 24DC/500AC-9 - 2900421
Dimensions
| Width |
22.5 mm |
| Height |
107 mm |
| Depth |
114 mm |
Back to top
Ambient conditions
| Ambient temperature (operation) |
-25 °C ... 70 °C (observe derating) |
| Ambient temperature (storage/transport) |
-40 °C ... 80 °C |
| Maximum altitude |
≤ 2000 m |
| Degree of protection |
IP20 |
Back to top
Device supply
| Rated control circuit supply voltage US |
24 V DC |
| Control supply voltage range |
19.2 V DC ... 30 V DC |
| Rated control supply current IS |
40 mA |
| Type of protection |
Surge protection |
| |
Reverse polarity protection |
Back to top
Input data
| Input name |
Control input right/left |
| Rated actuating voltage UC |
24 V DC |
| Triggering voltage range |
19.2 V DC ... 30 V DC |
| Rated actuating current IC |
5 mA (Input type 1) |
| Switching threshold |
9.6 V (“0” signal) |
| |
19.2 V (“1” signal) |
| Switching level |
< 5 V DC (For EMERGENCY STOP) |
| Typical turn-off time |
< 30 ms |
| Type of protection |
Reverse polarity protection |
Back to top
Output data load output
| Output name |
AC output |
| Rated operating voltage Ue |
500 V AC |
| Operating voltage range |
42 V AC ... 550 V AC |
| Rated operating current Ie |
9 A (AC-51) |
| |
6.5 A (AC-53a) |
| Mains frequency |
50/60 Hz |
| Load current range |
1.5 A ... 9 A (see to derating) |
| Trigger characteristic in acc. with IEC 60947-4-2 |
Class 10A |
| Cooling time |
20 min. (for auto reset) |
| Leakage current |
0 mA |
| Type of protection |
Surge protection |
Back to top
Output data reply output
| Output name |
Acknowledge output |
| Note |
Confirmation: floating change-over contact, signal contact |
| Contact type |
1 changeover contact |
| Switching capacity according to IEC 60947-5-1 |
3 A (230 V, AC15) |
| |
2 A (24 V, DC13) |
Back to top
Overspeed tripping
| Operate threshold |
> 45 A |
| Response time |
< 2 s |
Back to top
General
| Motor starter type |
Reversing starter |
| Switching frequency |
≤ 2 Hz (Load-dependent) |
| Mounting position |
vertical (horizontal DIN rail, motor output below) |
| Mounting type |
DIN rail mounting |
| Assembly instructions |
alignable, for spacing see derating |
| Operating mode |
100% operating factor |
| Maximum power dissipation |
14.6 W |
| Minimum power dissipation |
1.1 W |
| Operating voltage display |
Green LED |
| Status display |
Yellow LED |
| Indication |
Red LED |
Back to top
Connection data
| Connection name |
Control circuits |
| Connection method |
Screw connection |
| Stripping length |
8 mm |
| Screw thread |
M3 |
| Conductor cross section solid |
0.2 mm² ... 2.5 mm² |
| Conductor cross section flexible |
0.2 mm² ... 2.5 mm² |
| Conductor cross section AWG |
24 ... 14 |
| Torque |
0.5 Nm ... 0.6 Nm |
| |
5 lbf-in. ... 7 lbf-in. |
Back to top
Connection data 2
| Connection name |
Load circuit |
| Connection method |
Screw connection |
| Stripping length |
8 mm |
| Screw thread |
M3 |
| Conductor cross section solid |
0.2 mm² ... 2.5 mm² |
| Conductor cross section flexible |
0.2 mm² ... 2.5 mm² |
| Conductor cross section AWG |
24 ... 14 |
| Torque |
0.5 Nm ... 0.6 Nm |
| |
5 lbf-in. ... 7 lbf-in. |
Back to top
Insulation characteristics
| Rated insulation voltage |
500 V |
| Rated surge voltage |
6 kV |
| Overvoltage category |
III |
| Degree of pollution |
2 |
| Designation |
Insulation characteristics between the control input and control supply voltage, and auxiliary circuit to the main circuit |
| Insulation |
Safe isolation (IEC 60947-1/EN 50178) at operating voltage ≤ 300 V AC |
| |
Basic isolation (IEC 60947-1) at operating voltage 300 ... 500 V AC |
| |
Safe isolation (EN 50178) at operating voltage 300 ... 500 V AC |
| Designation |
Isolation characteristics between the control input and control supply voltage to auxiliary circuit |
| Insulation |
Safe isolation (IEC 60947-1) in the auxiliary circuit ≤ 300 V AC |
| |
Safe isolation (EN 50178) in the auxiliary circuit ≤ 300 V AC |
Back to top
Standards and Regulations
| Designation |
Standards/regulations |
| Standards/regulations |
IEC 60947-1 |
| |
IEC 60947-4-2 |
| |
IEC 61508 |
| |
ISO 13849 |
Back to top
Conformance/approvals
| Designation |
ATEX |
| Identification |
II (2) G [Ex e] [Ex d] [Ex px] |
| |
II (2) D [Ex t] [Ex p] |
| Certificate |
PTB 07 ATEX 3145 |
| Designation |
UL approval |
| Certificate |
NLDX.E228652 |
| Designation |
Safety Integrity Level (SIL, IEC 61508) |
| Identification |
≤ 3 |
| Additional text |
Safe shutdown |
| Designation |
Safety Integrity Level (SIL, IEC 61508) |
| Identification |
2 |
| Additional text |
Motor protection |
| Designation |
Performance Level (ISO 13849) |
| Identification |
≤ e |
| Additional text |
Safe shutdown |
| Designation |
Category (ISO 13849) |
| Identification |
≤ 3 |
| Additional text |
Safe shutdown |
Back to top
UL data
| SCCR |
100 kA (500 V AC (fuse: 30 A class CC/30 A class J (high fault))) |
| |
5 kA (500 V AC (fuse: 20 A RK5 (standard fault))) |
| FLA |
6.5 A (500 V AC) |
| Group installation |
20 A (class RK5, SCCR 5kA, #24 - 14 AWG max. solid and stranded) |
| |
30 A (class CC or J, SCCR 100kA, #24 - 14 AWG max, solid and stranded) |
| Category code |
NLDX |
Back to top
Environmental Product Compliance
| REACh SVHC |
Lead 7439-92-1 |
| China RoHS |
Environmentally Friendly Use Period = 50 years |
| |
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration”
|
